GEAR BOX 53 CAUTION Slide the lever eye end edges through the slots provided on the plastic bush. Otherwise the edges can damage the plastic bush. 4. Slide the “O” ring on the groove of plastic bush. 5. Press the gear shifter lever along with the bush inside the bore of extension arm. NOTE While pressing care should be taken that the arrow marks on the bush should be perpendicular to the extension arm. 6. Lock the bush on the extension arm by turning the lever and bush assembly in the clockwise direction by 90º such that the arrows on the bush should be in line with the extension arm as shown below. NOTE Make sure that the bush lug is properly seated in the extension arm slot. 7. Assembly extension arm with the insert block by tightening two nyloc nuts. 8. Slide the rubber bellow at the bottom of the gear shifter lever and place the bushes (2 Nos.) on to the gear shifter lever. 9. Assemble the shift link if dismantled. NOTE All bushes should be properly checked before assembly. Always apply grease 3% MOS 320 on the pins and inner surface of the bushes before assembly.
RkJQdWJsaXNoZXIy MTIwNTUz