CLUTCH 31 B. CONCENTRIC SLAVE CYLINDER REMOVAL 1. Disconnect battery connection. 2. Remove the stone guard and drain the clutch fluid from the hydraulic adapter. (For procedure refer clutch fluid draining procedure in this section.) 3. Pull out the clip using a screw driver and disconnect the high pressure line from peak torque limiter by pulling it out. Also remove the peak torque limiter in similar way. 4. Lower the gearbox from the vehicle. (For procedure refer gearbox removal in Gearbox section.) 5. Pull out the clip using a screw driver and disconnect the hydraulic adapter from the concentric slave cylinder (CSC) by pulling it out. WARNING Small quantity of fluid will be present in the concentric salve cylinder and hydraulic adapter; therefore care should be taken that fluid does not fall in the housing. 6. Loosen and remove concentric slave cylinder (CSC) mounting bolts (2 Nos.) from the clutch housing. CAUTION : Plug the opening with suitable cap to avoid entrance of any contaminations and dirt in the concentric slave cylinder. Flush the connecting parts/hose with clean clutch fluid before assembly to prevent contamination of the new cylinder.
RkJQdWJsaXNoZXIy MTIwNTUz