CLUTCH 24 C. PRECAUTION FOR ASSEMBLY OF SAC 1. Use only paired Clutch Disc & SAC set for assembly 2. Ensure same serial no. marking on SAC cover assembly & Clutch Disc. SAC Cover Assembly Clutch Disc Assembly 3. Don’t mix the disc from SAC-Set 1 to other SAC- Sets 2, 3, 4. The Release load is adjusted with same set of SAC and disc. You can recognize that a disc was measured with a SAC because of the same serial number. 4. SAC should be assembled with counter load only (i.e. without releasing the clutch) 5. Don’t engage or disengage a clutch cover without having a disc under the pressure plate. SAC will adjust irregularly and produces unpredictable. Release load and Clamp load and therefore Pedal load is also unpredictable. Don’t use this Set anymore. (Adjusting ring is inside cover notches, SAC is ok) (Adjusting ring is outside cover notches, SAC is not ok (Only in new condition)) 6. Don't release SAC without a clutch disc under pressure plate & unless the SAC is properly screwed to flywheel. 7. Replacement of the clutch should be as a set only. 8. Do not replace individual clutch disc or SAC. 9. In field strictly follow the procedure as mentioned in service manual 10. Ensure marking position on adjusting ring, if unfortunately a SAC adjust during mounting process, change the whole set. 11. Ensure that the clutch facing material is not contaminated with oil or grease as this shall result in clutch slipping.
RkJQdWJsaXNoZXIy MTIwNTUz