ENGINE 181 REMOVAL 1. Disconnect electrical connections of brake light switch (1) and brake switch for cruise control (2) (If fitted). 2. Loosen the mounting nut of brake switch and take out the brake switch by rotating anticlockwise direction. INSPECTION Disconnect the connector and check the continuity between the following pins. When the pedal is depressed there should be connectivity and when it is released to rest position there should not be connectivity. Brake Light Switch: Pins 1 and 2 for Brake light circuit. Pins 3 and 4 for Brake signal to EMS circuit Brake switch for Cruise Pins 1 and 3 for Brake pedal signal for cruise control. For switch adjustment details, refer brake section. PIN OUT PIN NO DESCRIPTION 1 Ignition 2 Supply to tail lamp 3 Ignition 4 Signal to EMS BRAKE PEDAL SWITCH (FOR VEHICLES WITH CRUISE CONTROL) PIN NO DESCRIPTION 1 Ignition 2 NC 3 Signal to EMS (Cruise Control) 4 NC REFITMENT 1. Fit the brake light switch on the mounting bracket and tighten its mounting nut. NOTE Refer brake section for brake switch adjustment details.
RkJQdWJsaXNoZXIy MTIwNTUz