ELECTRICAL 87 4. Press the lock button and push down the blade assembly from its location and take out the wiper blade assembly from wiper arm. INSPECTION: Inspect wiper blade rubber for any cut. If found, replace the wiper blade assembly. REFITMENT: 1. Before fitting the wiper arm and blade assembly bring the wiper motor to the parking position. This can be done by switching ON the Ignition and giving a single wipe. NOTE Switch OFF the Ignition only after the motor has stopped. 2. Fit the wiper arm in its parking position to the shaft locating it on the splines so that the wiper blade is just clear of the windshield glass. As shown in the below figure. 3. Make sure that the distance of wiper blade with respect to leaf screen mould is as shown in the below fig. Driver side Blade distance with respect to leaf screen mould A = 79 mm B = 83 mm Co-driver side Blade distance with respect to leaf screen mould a = 30 mm b = 24 mm NOTE: Co-driver side wiper ARM andblade assembly should be aligned with marking provided on the black band of the windshield glass. 4. Fit one mounting nut and tighten with specified torque. Tightening toque for Nut: 2.5 Kgfm 5. Fit the rubber cover. 6. Check the correct operation of wiper.
RkJQdWJsaXNoZXIy MTIwNTUz