BRAKES 34 TANDEM MASTER CYLINDER (TMC) : Removal : 1. Remove the leaf screen and panel for wiper motor mounting to have easy access to the TMC. (For procedure refer body section) 2. Remove the air filter assembly. (For procedure refer engine section) 3. Drain the brake fluid from the brake circuit. (For procedure refer brake fluid draining in this section.) 4. Remove the spring band clamp at the CMC end and hold the CMC to reservoir connecting line in vertically upward position to avoid any further loss of fluid and plug the openings with suitable cap. 5. Disconnect the electrical connection of fluid level warning indicator from the TMC. 6. Disconnect all the outlet lines from the master cylinder. 7. Loosen and remove the mounting nuts and remove the TMC assembly from the vehicle. Fitment : For fitment follow reverse procedure of removal. NOTE : Make sure that lines are fitted correctly i.e. primary outlet is connected to front brakes and secondary outlet is connected to rear brakes. Connect clutch hose After refitment bleed the brake circuit. Do not overhaul the TMC assembly as it is not serviceable and needs to be replaced as an assembly.
RkJQdWJsaXNoZXIy MTIwNTUz