BRAKES 20 3. Pull out and remove the excluder from the booster clevis. 4. Remove the filter cup from the booster assembly. INSPECTION : Check the external filter, excluder and filter cup for any cut, damage etc. If it is blocked do not clean and reuse, replace it with new one. Fitment : For fitment follow reverse procedure of removal. viii. GREASING : Drum In Hat Shoe Lining Greasing : 1 Remove the rear brake disc. (For procedure refer brake disc removal process in this section.) 2 A thin film of “Lithium Based Grease” to be smeared at below given locations. 3 Clean the location where grease to be applied. Keep grease away from shoe lining. Caliper Greasing : Loosen and remove the sliding pin and grease them with the special grease which is provided for brakes. NOTE : Check the sliding pin boot for any cut or damages. If any defect is found replace the boot.
RkJQdWJsaXNoZXIy MTIwNTUz