PROPELLER SHAFT 13 6. Remove the end yoke from the propeller shaft and place in a soft jawed vise to inspect the cross hole surfaces. Raised metal can be removed with a rat tail or half round file. Emery cloth should be used to remove all rust and corrosion from cross hole bores. ASSEMBLY OF UNIVERSAL JOINT 1. Position the cross in the yoke. 2. Move one end of the cross to cause a trunnion to project through the cross hole beyond the outer machined face of the yoke lug. Place a bearing assembly over the trunnion diameter and align it to the cross hole. Using an arbor press, hold the trunnion in alignment with the cross hole and place a solid plug on the upper bearing assembly. 3. Press the bearing assembly into the cross hole enough to install a snap ring. 4. Install a snap ring. 5. Peat the above steps to install the opposite bearing assembly.
RkJQdWJsaXNoZXIy MTIwNTUz