PROPELLER SHAFT 9 A. PROPELLER SHAFT (4X2) I REAR PROPELLER SHAFT REMOVAL 1. Loosen and remove the mounting nuts (Nos.4) of bearing strap from rear axle. Disconnect the rear end of the propeller shaft from the companion flange. 2. Pull out the propeller shaft from the slip joint at the centre bearing. FITMENT For fitment follow the reverse procedure of removal. II FRONT PROPELLER SHAFT REMOVAL 1. Remove the rear propeller shaft. 2. Remove the Stone guard rear piece from bottom side for easy access. (For stone guard removal procedure refer Body section) 3. Loosen and remove the bearing strap bracket retaining bolts at centre bearing joint from cross member. 4. Loosen and remove the mounting bolts for universal joint flange on the gear box side. Take out the front end propeller shaft from gear box. 3. Carefully remove the propeller shaft along with centre bearing, bracket and rubber cushion. FITMENT For fitment follow the reverse procedure of removal. NOTE Discard the Nyloc nut and use new at the time of assembly. Check the slip yoke assembly after fitment.
RkJQdWJsaXNoZXIy MTIwNTUz