REAR AXLE 40 11.While holding gears in place, insert turning bar into case. Pull on bar to rotate case allowing gears to turn. Make absolutely sure that the holes of the pinion mate are in alignment with holes of the case. 12.Pre-lubricate spherical washers. Torque forcing screw until it is tight. This will collapse the Belleville plates and allow clearance between gears. 13.Assemble spherical washers into case. Use a small screwdriver to push washers into place. 14.Remove tools and assemble cross pin shaft and drive in shaft with hammer. 15.Use the drift to replace the roll pin that retains the cross shaft. 16.When roll pin bottoms out, stake (Peen) a little metal over the edges in two places 180° Apart NOTE For further assembly of differential case into carrier section refer follow procedure as that of standard differential.
RkJQdWJsaXNoZXIy MTIwNTUz