REAR AXLE 16 FITMENT 1. Install the new inboard oil seal along with the shaft guide on the seal pressing dolly (Part No. 287058903501). 2. Apply the uniform Sealant Layer inside the oil seal bore. NOTE Use Anabond A-676 or 3M sealant. 3. Locate the inboard oil seal into the Bore and press fit the same with hammer blows on to the dolly (Part No. 287058903501) from nylon mallet. Fit the other end oil seal with same procedure 4. Insert the axle shaft (Spline end) through shaft guide and push axle shaft in as far as possible while aligning the brake assembly bolts with banjo beam flange holes. Engage the splines of axle shaft in the carrier section and push further. 9. Install the nuts and tighten the same. Apply the torque of 75 to 85 Nm (4Nos). 5. Ensure correct shaft (LH and RH) inserted on correct side. NOTE LH side Axle Shaft can be identified by Groove Mark on the Spigot face 6. Install brake disc and tighten the screw. 7. Install the parking brake cable, brake hoses and other attachments on the axle assembly. 8. Install the rear caliper assembly at both ends. 9. Fit the rear wheels. C. DIFFERENTIAL CASE REMOVAL 1. Support the vehicle on two post lift and remove tyres from rear end. 2. Drain the oil from the rear axle. (For procedure refer differential oil draining process.)
RkJQdWJsaXNoZXIy MTIwNTUz