REAR AXLE 13 13.4 ON VEHICLE REPAIRS A. REAR AXLE REMOVAL 1. Mount the vehicle on two post lift and remove tyres from rear end. 2. Disconnect the brake lines from the mounting bracket which is next to the silencer. (For procedure refer brake section). 3. Disconnect hand brake from both ends. (For procedure refer brake section.) 4. Remove the wheel speed sensor. (For procedure refer wheel speed removal in electrical section). 5. Disconnect the antiroll bar from the ball joint assembly by loosening the Nyloc nut. Follow the same procedure at the other end also. CAUTION Make sure that before loosening the Nyloc nut one should use Allen key (5mm) to hold the ARB link ball stud otherwise it may damage the ball joint. 6. Support the rear axle and remove the propeller shaft. (For procedure refer propeller shaft removal process). 7. Disconnect the upper link from the rear axle by removing the mounting bolt. Follow the same procedure at the other end also.
RkJQdWJsaXNoZXIy MTIwNTUz