FRONT AXLE (4X4) 26 4. Place shims selected as per procedure on pinion gear and install rear pinion bearing cone; using installer, rear pinion bearing cone (Part No. 270458903316) 5. Assemble bearing cone, slinger and new pinion seal into housing. Use Installer, pinion oil seal (Part No.289458903514). NOTE Apply a light coat of oil to the lip of oil seal. 6. Install new collapsible spacer onto pinion stem and assemble in housing. NOTE Collapsible spacer should rest on bearing inner race and Pinion Shoulder, and it can be fitted in any one direction. 7. Assemble end yoke, washer and new pinion nut. Tighten pinion nut using torque wrench by holding end yoke holder with help of special tool (Part No. 289458903517) Tighten nut to specified torque or until all end play is removed. Continue to tighten in small increments until specified rotating torque is achieved. NOTE Excessive care must be taken during bearing preload torque adjustment. Do not over tighten, loosen and then retighten nut. Do not exceed specified bearing preload torque. 8. If the preload torque is exceeded, a new collapsible spacer must be installed and torqueing sequence as above to be repeated. Check for torque of pinion.
RkJQdWJsaXNoZXIy MTIwNTUz