FRONT AXLE (4X4) 22 If excessive wear is noticed on all parts, it is recommended that the complete differential assembly to be replaced. If any gears are to be replaced, they must be replaced as sets. 13.Remove end yoke using tool as shown. Holder yoke. (Part.no.2894 5890 35 17) 14.If yoke shows wear in the area of seal contact, it should be replaced. 15.Remove pinion by tapping with mallet. 16.Hold the pinion with stand to avoid falling. CAUTION Gear teeth have sharp edges. Handle gears carefully to avoid injury. 17.Collect shims and keep them together. Replace shims if found damaged. NOTE Discard collapsible spacer. New one is required to be used during assembly 18.Pullout pinion oil seal with puller slide hammer. ( Part No.2894 5890 35 16) NOTE Discard the oil seal once removed and use new at the time of assembly. 19.Remove bearing cone and outer thrust washer. Turn nose of carrier down. Remove outer pinion bearing cup using tools given below. A. Remover outer pinion bearing cup along with baffle (Part No. 270458903310) B. Handle (Part No.289458903501) 20.Turn nose of carrier up and remove inner pinion bearing cup using tools given below. Remover for inner pinion bearing cup. (Part No. 2704 5890 33 15 ) Handle (Part No. 2894 5890 35 01) NOTE Pinion depth shim is located between inner pinion bearing cone and pinion gear.
RkJQdWJsaXNoZXIy MTIwNTUz