BRAKES (Non EPB) 30 D. REAR CALIPER ASSEMBLY WITH CARRIER REMOVAL 1. Apply parking brake & Keep the gear shift lever in neutral position. 2. Jack up the vehicle and remove wheels. Release the Parking Brake. 3. Remove hose from caliper body by taking out the banjo bolt and collect the brake fluid from caliper in a clean container. Block the brake hose using a dust cap to prevent loss of brake fluid and prevent contamination and keep the pipe in the vertically up-straight position. 4. Disconnect the parking brake cable from caliper. 5. Loosen and remove the mounting bolts of caliper assembly. 6. Remove the caliper assembly along with the carrier from the brake disc. NOTE If only the caliper housing has to be removed. Remove the banjo bolt and disconnect rear brake hose above Sr. No.3. Disconnect the parking brake cables from caliper. Remove both pin bolts and take out the caliper housing. FITMENT For fitment, follow the reverse procedure of removal. E. REAR CALIPER PAD REPLACEMENT. 1. Remove the both the Pin Bolts & take away caliper housing. NOTE During Pad replacement no need to disconnect the Brake hose as well as Parking Brake Cable. INSPECTION Measure the pad lining thickness if it is found to be 1mm or less anywhere, it has to be replaced. The inboard pads of rear brake are provide with the wear indicator. REAR BRAKE PAD INDICATOR
RkJQdWJsaXNoZXIy MTIwNTUz