SUSPENSION 35 10.Support the RTB using lifting trolley 541258900614 & fixture 541258900619. 11.Loosen (Do not remove) Panhard rod both side mounting bolts. 12.Loosen (Do not remove) RTB pivot bush LH/RH cross bolt. 13.Loosen (Do not remove) Damper bottom mounting bolt. 14.Remove the rear coil spring. 15.Remove the Panhard rod to BIW mounting bolt. 16.Remove the damper bottom mounting bolt LH/RH. 17.Remove the Pivot bracket mounting to BIW mounting 4 bolts LH/RH. 18.After above steps, hold the RTB properly and slowly lower fixture with the help of jacks supporting the RTB fixture. 19.In case of installation fixture is not available and jack is used as per step no 10, after above steps, hold the RTB properly and slowly lower the two jacks supporting the RTB at equal level. 20.Once the coil springs are sufficiently relaxed and free to move remove them and now the RTB can be removed from the vehicle along with PHR and pivot brackets attached to it Note: Tightening with snug torqueing and angle torqueing of Rear Suspension on body to be done in ECIE / Preload condition only. No jacking to be done on beam.
RkJQdWJsaXNoZXIy MTIwNTUz