KRYOTEC ENGINE 104 6. Check the engine oil level with the dipstick. NOTE Checking the oil level should be carried out with the vehicle on level ground. 7. Install the oil filler cap, run the engine at idle speed for about 2 minutes, turn off the engine and wait a few minutes. 8. When the engine is cold, check the oil level and check for leakage. 9. Install the belly pan (Refer to 13 - Frame and Bumpers/Under Body Protection/BELLY PAN/Removal and Installation). 10. Remove the support and lower the vehicle. I. OIL PAN REMOVAL 1. Disconnect and isolate the negative battery cable. 2. Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting - Standard Procedure). 3. Remove the right and left front tire and wheel assembly (Refer to 22 - Tires and Wheels/Removal and Installation). 4. Remove the belly pan (Refer to 13 - Frame and Bumpers/Under Body Protection/BELLY PAN/Removal and Installation). 5. Remove the right front wheelhouse splash shield (Refer to 23 - Body/Exterior/SHIELD, Splash/Removal and Installation). 6. Remove the left front wheelhouse splash shield (Refer to 23 - Body/Exterior/SHIELD, Splash/Removal and Installation). 7. Remove the front fascia (Refer to 13 - Frame and Bumpers/Bumpers/FASCIA, Front/Removal and Installation). 8. Remove the front suspension crossmember (Refer to 13 - Frame and Bumpers/Frame/CROSSMEMBER, Front Suspension/Removal and Installation). 9. Drain engine oil, using a NEW sealing washer, tighten drain plug to the proper (Torque Specifications). 10. Install the engine oil dip stick. 11. Drain the transmission fluid (Refer to 21 - Transmission and Transfer Case/Manual, C514 - 5-Speed/FLUID/ Standard Procedure). 12. Remove the left side half shaft (Refer to 03 - Differential and Driveline/Half Shaft/Removal and Installation). 13. Remove the right side half shaft (Refer to 03 - Differential and Driveline/Half Shaft/Removal and Installation). 14. Remove the Power Transfer Unit (PTU) (Refer to 21 - Transmission and Transfer Case/Power Transfer Unit/ Removal and Installation). 15. Remove the battery (Refer to 08 - Electrical/Battery System/BATTERY/Removal and Installation). 16. Remove the battery tray (Refer to 08 - Electrical/Battery System/TRAY, Battery/Removal and Installation).
RkJQdWJsaXNoZXIy MTIwNTUz