BRAKES 33 12. BRAKE PEDAL ASSEMBLY REMOVAL 1. To disconnect pedal from brake booster remove split pin as shown in fig. 2. Remove clevis pin to separate booster assembly from pedal. 3. Loosen and remove the brake mounting M8 nuts from panel firewall RHD. 4. Loosen and remove the clutch pedal bracket and lever assembly. 5. Pull out the brake mounting bracket along with brake pedal from the driver’s foot control area. INSTALLATION 1. Hold the brake control bracket on firewall. 2. Tighten the brake upper mounting M8 nut. 3. Tighten the brake mounting M8 nuts on panel firewall RHD. 4. Match clevis hole to the pedal lever hole and insert clevis pin into the hole. 5. Insert split pin in to the hole of clevis pin and split the end of split pin. NOTE: 1. Not to add carpet over the basic carpet in the pedal region. 2. Basic carpet should be held firmly in the pedal region.
RkJQdWJsaXNoZXIy MTIwNTUz