DRIVESHAFT AMT 10 10. Place the remaining grease from the service kit inside the seal and slide the larger diameter of the seal with the larger seal retaining clamp in place over the outside of CV joint. Important: The CV seal must not be dimpled, stretched or out of shape in any way. If seal is not shaped correctly equalize pressure. 11. Crimp the seal retaining clamp using pincer tool and maintain ear gap of 2.6 mm. 7. ON VEHICLE DRIVE SHAFT REMOVAL 1. Disconnect Battery –Ve Terminal. 2. Remove Wheel. 3. Drain Transaxle oil. 4. Remove Suspension Mtg. vertical link (antiroll bar) from Strut on LH & RH side.
RkJQdWJsaXNoZXIy MTIwNTUz