DRIVESHAFT_PETROL 12 10. Separate the housing assembly from the seal at large diameter as shown in figure Slide the seal away from the joint axle shaft. 11. Remove the spider assembly circlip by using plier and discard the retaining ring. 12. Remove the tripot spider assembly from the axle shaft as showing below figure. If required tab the spider assembly gently using a nylon mallet. 13. Clean the following items thoroughly with cleaning solvent. Remove all traces of old grease and any contaminates. a. Tripot balls b. Needle rollers c. Housing Dry all the parts. Inspect these parts for damage or wear.( If any of the parts are damaged, the entire sub- assembly along with the outer housing needs to be replaced.) After this remove the rubber boot from the axle shaft.
RkJQdWJsaXNoZXIy MTIwNTUz