CLUTCH_PETROL 17 B. CLUTCH CABLE REMOVAL AND INSPECTION: REMOVAL 1. First loosen the clutch cable nut from clutch release lever end. 2. Remove the clutch cable form the “B” mount Hole. 3. Remove mounting bolt on Clutch cable holding bracket mounted on BIW, then separate the clutch cable. 4. Now let’s go to driver compartment & disconnect the Clutch Cable from clutch pedal lever hook, by lifting up clutch pedal. 5. Finally, clutch cable to be loosen from firewall by removing the two mounting nuts of clutch cable, from driver compartment & take out the clutch cable form engine compartment. INSPECTION Replace the cable if 1. There are any permanent bends or kinks. 2. The cable is having a worn end. 3. The cable boot is broken in the engine compartment. 4. The inner cable strands are broken. INSTALLATION 1. Grease the Clutch Cable roller. 2. Insert the Clutch Cable inside the firewall, clutch cable mounting hole and mount the clutch cable abutment on firewall by using two M6 Hex flange nut and applied appropriate tightening torque (0.8-1 kgm), Insure that the clutch cable is free inside the abetment. 3. Insert the Clutch Cable in the clutch pedal lever hook, by lifting the clutch pedal upward. 6. Install Clutch cable properly inside the Cable holding bracket mounted on BIW, then tighten
RkJQdWJsaXNoZXIy MTIwNTUz