TRANSAXLE - TA65 Star 30 34. Pry out the input shaft, and lay shaft along with shifter shaft assembly from the clutch housing. 35. Remove the differential assembly along with the oil seal and taper roller bearing from the housing front. 36. Remove the input shaft cover by removing M6 * Mounting Bolts. 37. Try out the oil seal from the cover (if damaged) and replace it with new one. 38. Remove the plastic bushes at both ends of clutch release fork and remove the clutch release shaft from inside. 39. Remove oil seals of drive shaft from differential housing. Replace it with a new one while assembling. 40. Remove bearing outer races of differential side bearing along with shims. Ensure that outer races are not interchanged. NOTE: 1. SHIMS SHOULD NOT BE REUSED. 2. Apply anabond 112 on threads of all fasteners 3. Apply RTV silicon liquid gasket anabond 676 on housing interface. 4. The chips collected by magnetic drain plug, are to be removed at the time of every oil change. 5. Keep inner and outer races of taper roller bearing in sets. 6. Use sealing anaerobic compound for all oil seals outer diameter. 7. For oil seals of input drive shaft and bellows use anabond 112.
RkJQdWJsaXNoZXIy MTIwNTUz