TRANSAXLE - TA65 Star 22 9. Disconnect vehicle speed sensor connection from transaxle. 10. Remove ball joint (steering rack) from steering knuckle from both sides. 11. Remove Mountings on lower control arm and disconnect lower control arm. 12. Swing out both drive shafts from transaxle and hang it suitably with the help of hook 5123 5890 2403. CAUTION: Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. 13. Disconnect electrical connections of Reverse Light switch. 14. Ensure to release wiring harness from below clutch cable and clutch actuating lever. 15. Disconnect earthing cable Gear Box 16. Support engine suitably using engine lifting crane. 17. Remove the starter motor. 18. Loosen and remove B Mount nut.
RkJQdWJsaXNoZXIy MTIwNTUz