KRYOTEC ENGINE 90 46. Install the battery (Refer to 08 - Electrical/Battery System/BATTERY/Removal and Installation). 47. Evacuate and charge the refrigerant system (Refer to 24 - Heating and Air Conditioning/Plumbing - Standard Procedure). 48. Fill the cooling system (Refer to 07 - Cooling - Standard Procedure). 49. Fill the transmission (Refer to 21 - Transmission and Transfer Case/Manual/FLUID/Standard Procedure). 50. Bleed the clutch hydraulic circuit (Refer to 06 - Clutch/Standard Procedure). 51. Install the front fascia (Refer to 13 - Frame and Bumpers/Bumpers/FASCIA, Front/Removal and Installation). 52. Install the front wheel splash shields (Refer to 23 - Body/Exterior/SHIELD, Splash/Removal and Installation). 53. Install the front belly pan (Refer to 13 - Frame and Bumpers/Under Body Protection/BELLY PAN/Removal and Installation). 54. Install the front wheels (Refer to 22 - Tires and Wheels/Removal and Installation). 55. Remove the vehicle from the lift. C. CYLINDER HEAD REMOVAL 1. Remove the battery tray (Refer to 08 - Electrical/Battery System/TRAY, Battery/Removal and Installation). 2. Remove the engine cover (Refer to 09 - Engine/COVER, Engine/Removal and Installation). 3. Remove the EGR cooler (Refer to 25 - Emissions Control/Exhaust Gas Recirculation, Diesel/COOLER, Exhaust Gas Recirculation (EGR)/Removal and Installation). 4. Remove the cylinder head cover (Refer to 09 - Engine/Cylinder Head/COVER(S), Cylinder Head/Removal and Installation). 5. Disconnect the glow plugs wire harness connectors 1). 6. Disconnect the boost pressure sensor wire harness connector (1).
RkJQdWJsaXNoZXIy MTIwNTUz