KRYOTEC ENGINE 74 ix. CHECKING ENGINE OIL PRESSURE 1. Run the engine until it reaches normal operating temperature. 2. Disconnect and isolate the negative battery cable. 3. Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure). 4. Remove the belly pan (Refer to 13 - Frame and Bumpers/Under Body Protection/BELLY PAN/Removal and Installation). 5. Disconnect the oil pressure switch wire harness connector. 6. Remove the oil pressure switch. 7. Install the 1860969000 fitting (1a), 2000024300 fitting (1b), and 2000018801 Tee (1c) into the engine oil pressure switch port. 8. Install the 2000015600 Connection Tube Manometer (1) into the previously installed fittings. 9. Install a suitable pressure gauge (1) and check to see if the engine oil is within the prescribed limits. Delivery pressure Engine oil (Idle ) 1.0 bar Delivery pressure engine oil (4000 RPM) 4.0 - 4.2 bar 10. Remove the pressure gauge and fittings. 11. Install the oil pressure switch and tighten to the proper (Torque Specifications). 12. Connect the oil pressure switch wire harness connector. 13. Install the belly pan (Refer to 13 - Frame and Bumpers/Under Body Protection/BELLY PAN/Removal and Installation). 14. Remove the support and lower the vehicle. 15. Connect the negative battery cable.
RkJQdWJsaXNoZXIy MTIwNTUz