BODY 65 1.4.54 WATER CHANNEL MAINTENANCE 1. Remove Moving Glass Panel & Fixed Glass Panel. 2. Inspect drain holes on water channel (2-a) and rear part (2-b), remove the dust and leaves if present. Use vacuum cleaner if necessary. 3. Re-assemble Moving Glass Panel & Fixed Glass Panel then close sunroof, inspect gap and step difference between Moving Glass Panel & Fixed Glass Panel. Inspect flushness with Body Roof. 1.4.55 SUNROOF RESET PROCEDURE - INITIALIZING THE POWER SUNROOF Please first read and note the introductory information and attention to WARNINGS! Condition for initializing the sunroof If the vehicle battery has been disconnected during Sunroof / Sunshade Rollo movement and reconnected or is dead or replace the fuse, the sunroof/Sunshade Rollo must be initialized. Otherwise Express (one touch) function (open/close/tilt) and pinch protection function will be deactivated. Initializing command procedure: To initialize the sliding sunroof and Sunshade Rollo, use the following procedure. 1. Turn ON the ignition 2. Close the sunroof fully by pressing ‘sunroof close switch’ and keep the switch pressed for few seconds after the roof is fully closed, till clicking sound comes from Sunroof. 3. Close the Rollo shade fully by pressing ‘Sunshade Rollo close switch’ and keep the switch pressed for few seconds after the Rollo shade is fully closed, till clicking sound comes from Rollo shade. 4. Check if the Express open/close features are working. NOTE If the initializing procedure is not completely performed, then it has to be run again from step 2.
RkJQdWJsaXNoZXIy MTIwNTUz