FATC 22 8. FATC UNIT The front HVAC unit comprises of the following parts: A. BLOWER The Blower is located on the right top side of the HVAC unit when viewed from inside the car. It acts as a centrifugal pump drawing in air from the center and pushing it out diagonally. The air flows through the evaporator and the heater coil and then to the cabin. The Blower speed is control by blower control module. SPECIFICATION : BLOWER MOTOR MODEL HYOSUNG VOLTAGE DC 12.5 V CURRENT 25A 10% MAX RATING TORQUE 0.56 Nm @12.5 V RATING SPEED 3800 300 rpm RATING OUTPUT 313 W MAX AIR FLOW 545 M3/HR CLAMPING TORQUE (FLANGE NUT) TBD N.m B. EVAPORATOR COIL AND TXV (THERMAL EXPANSION VALVE) EVAPORATOR COIL It is a heat exchanger cum dehumidifier, which absorbs heat and moisture of the air passing through it to give cold dehumidified air. As the refrigerant absorbs the heat it changes its state from liquid to vapour. A thermistor (temperature sensor) is used to measure the temperature of the air passing over the evaporator in order to avoid freezing. TXV (THERMAL EXPANSION VALVE) The TXV used is block type valve. It consists of a two passages one for refrigerant flowing into the evaporator and the other for refrigerant coming out of evaporator and into the compressor. A temperature sensing element is placed in the outlet passage. This sensing element is filled with a fluid which expands and contracts when there is rise or fall in the temperature. When the temperature of the refrigerant flowing out of the evaporator rises it causes the expansion of the refrigerant in the sensing element which in turn pushes the pin, such that the ball valve blocking the orifice opens to allow more refrigerant into the evaporator. The pressure spring provided below the ball tends to close the ball valve and hence this pressure has to be overcome in order to open the valve. There is a passage in the block valve where refrigerant flowing out can build pressure under a diaphragm on which the sensing element is mounted causing the diaphragm to move up; this provides the needed pressure correction while regulating the refrigerant into the evaporator.
RkJQdWJsaXNoZXIy MTIwNTUz