SUSPENSION 37 INSTALLATION Follow Reverse procedure for Installation of Torsion Beam. NOTE: Apply soap water to the bush and the bore of twist beam assembly before installation. Tightening of RTB on body to be done in ECIE condition. No jacking to be done on beam, avoid oil based lubricant while pushing the bushes in eye. All RTB mounting fasteners to be fitted in ECIE condition (applicable wherever bush fasteners) Gen-3 Installation Procedure: 1. It requires specific care for bolt tightening sequence and torque value. 2. Sequences of bolt tightening of inner flange into the knuckle/RTB normally carried out as described in view H 2-3 Kg-m. 3. Tightening torque value (pre tension) is applied to bolts in sequence of 1-3-2-4. 4. Bolt tightening sequence must be followed to avoid abnormal residual face deformation of gen-3 bearing. INSTALLATION Follow Reverse procedure for removal of Torsion Beam. 22. RTB BUSH INSTALLATION 1. Place the Spacer Cup (1) inside of RTB 2. Place Puller cup (5) outside of RTB align with RTB Bush (2) 3. Insert the bolt from spacer cup(1) side and tighten the nut until RTB Bush will come out 4. While bush fitment, no undue deflection/twist/bending to be induces on the blade 5. Finally Tighten the nut until the bush come out from the RTB
RkJQdWJsaXNoZXIy MTIwNTUz