DRIVESHAFT (AT) 20 While disengaging driveshaft from gearbox take care that intermediate bearing bracket should not be damage. Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot. Do not place the drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. FITMENT OF RH DRIVESHAFT 1. Align & Insert the driveshaft at gearbox end through intermediate bracket. NOTE: While Assembly driveshaft to gearbox take care that intermediate bearing bracket should not be damage. 2. Assemble the Intermediate shaft bearing mounting bracket with torque 1.5 – 1.7Kgm. NOTE: Groove (shown by arrow) of the bearing mounting bracket should be at lower end 3. Insert the driveshaft at knuckle end & rotate the driveshaft nut to pull the driveshaft in knuckle. 4. Insert the LCA ball joint in knuckle & tighten the mounting fastener with torque .4.9 ± 0.7 kgm & angular torque 180°±5°.
RkJQdWJsaXNoZXIy MTIwNTUz