KRYOTEC ENGINE 105 17. Remove the Diesel Particulate Filter (DPF) (Refer to 11 - Exhaust System/FILTER, Diesel Particulate/Removal and Installation). 18. Remove the flywheel (Refer to 06 - Clutch/ FLYWHEEL/Removal and Installation). 19. Remove the bolt (1) and the oil vapor recovery hose. 20. Remove the oil pan bolts (2). 21. Using a suitable tool cut the sealer and remove the oil pan (3). 22. Remove the oil pump intake connector gasket. 23. Clean the residual sealant from the oil pan and engine block sealing surfaces. FITMENT 1. Install a NEW gasket seal onto the oil pump intake. NOTE No interruptions in the bead of sealant. 2. Apply a bead of silicone sealant to the oil pan. NOTE During assembly of the engine oil sump careful not to damage the bead of sealant. NOTE Complete assembly operations within 10 minutes of applying the sealant. 3. Install the oil pan and tighten the bolts (1) finger tight. 4. Tighten the oil pan bolts (1) to the proper (Torque Specifications). 5. Install the oil vapor recovery hose and tighten the bolt (2) to the proper (Torque Specifications). 6. Install the flywheel (Refer to 06 - Clutch/FLYWHEEL/Removal and Installation). 7. Install the clutch assembly (Refer to 11 - Exhaust System/FILTER, Diesel Particulate/Removal and Installation). 8. Install the Diesel Particulate Filter (DPF) (Refer to 11 - Exhaust System/FILTER, Diesel Particulate/Removal and Installation). 9. Install the battery tray (Refer to 08 - Electrical/Battery System/TRAY, Battery/Removal and Installation). 10. Install the engine cover (Refer to 09 - Engine/COVER, Engine/Removal and Installation). 11. Install the Power Transfer Unit (PTU) (Refer to 21 - Transmission and Transfer Case/Power Transfer Unit/ Removal and Installation). 12. Install the right side half shafts (Refer to 03 - Differential and Driveline/Half Shaft/Removal and Installation). 13. Install the left side half shaft (Refer to 03 - Differential and Driveline/Half Shaft/Removal and Installation). 14. Install the front suspension crossmember (Refer to 13 - Frame and Bumpers/Frame/CROSSMEMBER, Front Suspension/Removal and Installation). 15. Fill the transmission fluid (Refer to 21 - Transmission and Transfer Case/Manual, C514 - 5-Speed/FLUID/ Standard Procedure).
RkJQdWJsaXNoZXIy MTIwNTUz