KRYOTEC ENGINE 57 B. ENGINE INSTALLATION 1. Engine installation is generally reverse of removal. Make certain all hardware is tightened to appropriate torque specification. 2. Add the appropriate quantity of Engine oil, Transaxle oil and coolant with respective systems. 3. Connect the battery positive cable and then the battery negative cable. 4. Crank the engine several times without allowing the vehicle to start. This allows the oil and coolant to flow through engine. 5. Start the engine and verify the oil pressure light on the instrument cluster goes out. Stop the engine immediately if the light fails to extinguish. 6. Allow the engine to run for several minutes, checking for fluid levels and leakage. C. EXHAUST SYSTEM ON VEHICLE REPAIRS A. TAIL PIPE (MAIN SILENCER) REMOVAL 1. Loosen and remove the Pipe in pipe joint clamp bolt and disconnect the Tail Pipe assy. from main silencer. 2. Remove all supporting rubber hangers tail pipe. 3. Take out the tail pipe. FITMENT For fitment follow the reverse procedure of removal.
RkJQdWJsaXNoZXIy MTIwNTUz