Anti-lock Braking System(ABS) 19 Installation: A. Clean speed sensor and its mounting surface. B. Route the cable properly. C. Connect the wiring harness connector to wheel speed sensor cable. D. Make sure that the sensor cable connector is fully seated and locked into vehicle wiring harness connector. E. Insert the sensor into the sensor mounting hole and tighten the bolt to the specified torque (1.0 Kg-m). F. The Air gap should be 0.475mm to 1.175. G. Clear all fault codes and road test the vehicle to ensure proper operation of the brake system. C. FRONT MAGNETIC ENCODER : Inspection: 1. Front wheel, Knuckle and Bearing needs to be removed for Encoder Inspection. (for procedure refer front Axle section 2. If any damage is visible on encoder rubber strip on bearing replace the bearing with encoder strip. (Refer front Axle section for for bearing replacement procedure)
RkJQdWJsaXNoZXIy MTIwNTUz