SUSPENSION 32 18. REMOVAL AND ASSEMBLY OF REAR DAMPER ASSEMBLY AND COIL SPRINGS 1) Lift the car using two-post lift. 2) Remove Rear Wheel. 3) Position the hydraulic jack below the knuckle of cross beam in such a way that it slightly compresses the spring. 4) Loosen rear Damper Assembly bottom fastener. 5) Similarly carry out the above steps for the other side. 6) Remove both the Damper Assembly fasteners holding the torsion beam using hydraulic jack at any one side. 7) Now slowly release and hold the hydraulic jack pressure so that both the coil springs along with top rubber can be pulled out. CAUTION: Do not lower the torsion beam below certain level as the brake hoses will be damaged. 8) Remove Rear Damper Assembly top mounting on Body. 9) Remove Rear Damper Assembly. FITMENT Follow the reverse procedure. 19. ECIE CONDITION Vehicle to be kept on flat surface and static condition 1 Person weights = 68 kg, Luggage = 7 kg, Two persons on front row with luggage = 2 X (68+7) = 150 kg One person on 2nd (rear) row 1X (68+7) = 75 kg Extra luggage in boot area =30 kg Fuel = 90%
RkJQdWJsaXNoZXIy MTIwNTUz