TRANSAXLE 136 3. Position the ‘Transmission Control Unit’ over the electro valve block, still using for reference the two ‘Special tool – guide rods’ and moving it parallel towards the mating surface. Insertion of all the electro valves, pressure sensor and ground tabs must be obtained by appropriate load on the ‘Transmission Control Unit’ heat sink and following handling precautions. 4. Once the ‘Transmission Control Unit’ is positioned mated to the electro valve block, remove the two ‘Special tool – guide rods’. 5. Insert the new four ‘Transmission Control Unit’ fixing screws into the corresponding holes and tighten each screw by applying a torque of 6.0 ± 1.2 Nm, following the order shown in the image below. Please consider that screw on pos. 1 is M5 x 55and screws on pos. 2, 3 and 4 are M5 x 68. 6. Engage the two female connectors with the cable on the ‘Transmission Control Unit’.
RkJQdWJsaXNoZXIy MTIwNTUz