TRANSAXLE 126 Installation: NOTE 1. New AMT kit will be supplied with oil. Ensure oil level in reservoir and top up oil if necessary. 2. Ensure AMT kit engage piston slot is at center (Neutral) and transaxle is in neutral prior to assembling. 3. A new AMT kit is supplied with rubber collar to plug the hole provided for ‘AMT kit breathing so that AMT Kit hydraulic oil does not leak during transportation. This needs to be removed before kit fitment on transaxle otherwise it may lead to abnormal operation of AMT Kit. 1. Before proceeding to install ‘AMT KIT’, remove the old sealant thoroughly and clean the assembly by air. 2. Clean ‘AMT KIT’ base mounting plate by air and apply the fresh sealant properly (Silicon liquid gasket three bond 12S001 or ANABOND 690). 3. Ensure that interface finger is in neutral position (this can be done by pushing the selector shifter shaft vertically downwards. If it moves it is in neutral. Otherwise rotate it to bring it in neutral).Bring the slot of engage piston of the AMT kit approximately at the center (it will be in the same line as selection piston center). Assemble the AMT kit carefully by using the studs on the AMT top cover for alignment.
RkJQdWJsaXNoZXIy MTIwNTUz