70 ENGINE 273 MPFI FUELFILTERREPLACEMENT Inspection: a) Release the fuel system pressure. (Refer Fuel System) b) Position the car on two post lift. c) Install pressure gauge having a range of 0-10 bar at the delivery port. d) Connect fuel pump connectors. e) Run engine at idle condition. f ) Check fuel pressure on gauge. It should be min. 3.5 bar. If it is less than 3.5 bar, replace filter and retest. Removal Procedure: 1. Repeat steps (a) and (b) as mentioned above. 2. Place fuel container under fuel filter. 3. Disconnect inlet and outlet fuel lines from fuel filter. Remove fuel filter from clamp. Collect fuel emerging during the operation in suitable container. CAUTION A small amount of fuel may be released after fuel hose is disconnected. To avoid the chance of accident, cover hose and pipe disconnected with a shop cloth. Replace the f i l ter element regular ly at recommended service intervals. Fitment Procedure: 1. Connect inlet hose, outlet hose to filter. Ensure that quick fix connectors are fitted properly. 2. The arrow stamped on the outer case of the filter indicates the fuel flow direction. 3. Assemble filter on clamp. . 4. With engine ‘OFF’ condition and ignition switch ‘ON’ check for fuel leakage. 5. Start engine and check each joint of fuel system for leakage. Rectify if necessary.
RkJQdWJsaXNoZXIy MTIwNTUz