ELECTRICAL 701 ELECTRICAL REMOVAL 1. Disconnect the electrical connection 2. Loosen the locking nut & take out the switch INSPECTION : Brake l ights (stop l ights) are activated by a mechanical switch on the brake pedal. To test a suspected bad stoplight switch, bypass it with a jumper wire. The stoplights should light when the wires are connected. Use the test light to see if there is power at one of the lights. • If the lights come on when the wires are connected but not when the brakes are applied, replace the switch. • If the stoplights operate without the key on, remove the stoplight fuse before removing the switch. • If the new switch is adjustable, adjust it so that it is open when the pedal is released. The lights should come on about 1/4" after the pedal is applied. Also for switch adjustment details, refer brake section. REFITMENT 1. Tighten the locking Nut. 2. Connect the electrical connection STOP LIGHT SWITCH FUNCTION: It sends signal to instrument cluster when the brake pedal is pressed. This indicates operating of the brake. LOCATION It is located on bracket of brake pedal. INSPECTION : Test the switch with a Multimeter. Remove the rubber grommet covering the door switch and remove one of the electrical lead wires of the switch from its terminals. Clip one probe of the VOM to each switch terminal and shut the door. If the meter reads zero, the switch is working. If the meter reads higher than zero, the switch is faulty and should be replaced. REFITMENT : 1. Fit the door switch screw. 2. Fit the rubber grommet. 3. Connect the electrical connection.
RkJQdWJsaXNoZXIy MTIwNTUz