652 ELECTRICAL HEAD LAMP BEAM ADJUSTMENT The head light must be properly aligned in order to maintain maximum road safety as regards proper road illumination and to reduce the glare on the on coming traffic. It is recommended to check the alignment of Head Lamps periodically and whenever bulbs are replaced. Before adjusting the headlamp beam : 1) The tyre pressure should be as specified and the car should be on level ground. 2) The car should in unladen condition (only driver, spare wheel & STD accessories). 3 The car should be rolled for a few meters after loading to allow the springs to settle. 4) The headlamp should be set one at a time by either putting off the opposite side lamps or masking. 5} Use suitable screwdriver of required length to reach the toothed wheel adjustment. 6) The head lamp leveling switch should be in “zero” position. Procedure for aligning & leveling setting of headlamps beam : 1. Dimension, Arrow, lines and values should not appear on the screen. 2. Screen colour should be light and non-reflecting and marking lines should be dark and of 5 mm thick with sharp features. 3. The setting to be checked with the vehicle against the screen. Adjust the focussing (Horizontal movement) and leveling ( Vertical movement) only if required. To align the lamp low beam pattern against the dividing line on the board for respective headlamps (LH&RH). Refer lamp view for location & direction of screw driver rotation w.r.t movement of adjustment.
RkJQdWJsaXNoZXIy MTIwNTUz