STEERING SYSTEM 573 STEERING 6. While fitting steering rack and pinion assembly, make sure that there are NO sharp edges or weld burrs on knuckle otherwise it may cut outer ball joint assembly. The location of possible area is shown by arrow in figure. 7. While fitting steering rack and pinion assembly, check for FREE PINION ROTATING TORQUE (FPT) (8 - 13 Kg-cm) 8. Whenever a new steering rack and pinion assembly is to be fitted, always check for FREE movement of rubber bellow with tie rod i.e. check for grease application inside rubber bellows on tie rods. 9. Always make sure to CENTRALIZE steering wheel after replacement. 10.All FASTENERS should be tightened to their specified torque values. WARNING : Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Groove
RkJQdWJsaXNoZXIy MTIwNTUz