SUSPENSION SYSTEM 449 SUSPENSION ANTI-ROLL BAR Removal : 1. Disconnect the battery terminal, 2. Apply parking brake and place wheel chocks at rear, 3. Remove anti-roll bar nuts, washers and rubber cushions. Do not remove nyloc nut connecting antiroll bar and ball joint pin. 4. Remove anti-roll bar mounting bracket and bearing blocks. 5. Remove anti roll bar. Installation : 1. For installation, proceed in reverse order of removal, 2. Assemble ball joint pin to anti roll bar separately. Ensure ball joint face is parallel to mounting face of anti-roll bar. Tighten ball joint to anti-roll bar, 3. Assemble anti roll bar components but do not tighten. Ensure the paint mark is on upper direction of vehicle.Align bearing block outer face with crimp washer inner face to centralize anti-roll bar. 4. Assemble ball joint, rubber bush, cup and plain washer as shown below .By holding the hex on the shank of the ball joint with a spanner, keep on tightening the lower nyloc nut till the threads protrude about 5 to 6 mm outside the nut.
RkJQdWJsaXNoZXIy MTIwNTUz