DRIVETRAIN 415 DRIVETRAIN 7. Insert open jaw like tool between housing face and driveshaft tulip joint and loosen drive shaft from transaxle end. CAUTION : Do not remove driveshaft with the help of screwdriver as it may cause damage to seal. 8. Pull out drive shaft from transaxle end followed by wheel end by holding tulip. Do not hold on boots while removing. This will damage the boot. CAUTION : Do not pull the drive shaft as shown. CAUTION : (a) Do not bend the driveshaft while pulling. The bending angle of the tripod joint should be as low as possible. Over bending the tripod joint could lead to ser ious damage such as rol ler disassembly or even roller damage.
RkJQdWJsaXNoZXIy MTIwNTUz