ENGINE 273 MPFI 191 ENGINE OIL SUMP & OIL STRAINER Oil Sump Removal Procedure: • Position the car on a two post lift. • Drain the oil from oil sump. (Refer Engine Oil Drain Procedure) • Unscrew the hexagonal mounting bolts using ring spanner. • Take out the oil sump from engine block. • Remove liquid gasket using scrapper. • Clean the oil sump properly to remove any foreign particles, if present. • Check oil sump for leakage or damage. Replace it if found damage. Refitment Procedure: • Apply SEALANT LOCTITE 5910 black colour on oil sump mating surface on block to ensure leak proof joint. • Tighten the hexagonal mounting bolts using ring spanner at specified torque. Inspection: • Check for oil leakage when engine is started. CAUTION Risk: Methyl Ethyl Ketoxime, which may cause eye irritation and may cause sensation if in contact with skin, if released during curing. Safety: Avoid contact with skin and eyes. Keep out of reach of children. First Aid: In case of contact with eyes, rinse off immediately with plenty of water and contact a doctor or Poisonous Information Centre. If swallowed, do not induce vomiting, contact a doctor or Poisonous Information Centre immediately and show the container or the lable. After contact with skin, wash immediately with plenty of soap and water. If effect persists, seek medical attention. For best results, clean and dry all surfaces with a residue free solvent. Apply continous and even bead of silicone to one surface surrounding all bolt holes. Remove excess with knife at once. Assemble parts immediately. Do not squeeze out silicone by overtightening bolts. Retorque will not be necessary. Cures to touch in an hour and fully cures in 24 hours measured at 21ºC and 50% relative humidity. Allow more time in colder or dryer condition. NOTE
RkJQdWJsaXNoZXIy MTIwNTUz