ELECTRICAL 42 Sr No DTC Code DTC Descriptio n Minimum Time for Fault Setting / Tester Visibility, Assuming Fault was created while Ignition was OFF Impact on customer Probable cause Investigation/Rectificati on/Repair action 26 B1935 09 Mode Switch Button Stucked MODE Knob continuous press > 20 sec Customer will not able to do the clock settings, Illumination setting, scrolling of display screen and one time odo reset till this DTC is active. Mode button damage Check Button mechanism 27 U1604 55 Control Module Configurati on - not configured 100mS Cluster will not work or partially work Incorrect EOL or service procedure 1. Reset the ECU 2. If DTC still present; replace ECU Hardware 28 U1006 04 Control Module Internal - System Internal Failures 100mS Cluster will not work or partially work IPC internal damage 1. Reset the ECU 2. If DTC still present; replace ECU Hardware 29 P0605 00 Internal Control Module Read Only Memory (ROM) Error - no sub type information 250mS Cluster will not work or partially work • ECU ROM Failure • Incorrect Software (Application) Flashed 1. Reset the ECU 2. If DTC still present; replace ECU Hardware 30 P062F 01 Internal Control Module EEPROM Error - General Electrical Failure 100mS Cluster will not work or partially work • ECU EEPROM Failure • Incorrect Software (Configuration/Application) Flashed 1. Reset the ECU 2. If DTC still present; replace ECU Hardware
RkJQdWJsaXNoZXIy MTIwNTUz