ENGINE 273 MPFI 115 ENGINE Refitment Of Cylinder Head On Cylinder Block: • Lock the flywheel with the “flywheel locking pin” (Part No. 2834 5890 06 14). • Rotate camshaft and bring valve of 1st cylinder to compression TDC position by orienting the slot to horizontal and upside position by using camshaft locking plate (Part No. 2834 5890 06 20). • Assemble reed plate • Place the cylinder head gasket on the top of cylinder head. • Place the cylinder head on the block. • Tighten the cylinder head mounting bolts to the specified torque as per the tightening sequence and procedure as shown below. • Steps to tighten cylinder head bolt, M10 X 118L (Applicable for hand tightening). 1. Use all fresh bolts & washers along with a fresh gasket 2. Check the bolt collar seating surface on the cylinder head. It should be clean and not deformed. 3. Torque 1 Kg-m to all bolts as per sequence 4. Torque 3 Kg-m to all bolts as per sequence
RkJQdWJsaXNoZXIy MTIwNTUz