GENERAL 5 Important Information Always ensure your vehicle has sufficient petrol in the tank. In case of fuel mode switching from PETROL to CNG mode during normal running CNG indicator lamp turns ON. DO’s Always get the vehicle repaired/serviced at the Authorized TATA Service only. Never carry out any repair work on your own or from any other personnel other than from Authorized TATA Service center. Check CNG fuel system periodically for leakages. Even though the Safety Solenoid valves (on cylinder & pressure regulator) closes automatically when you switch off the Ignition, it is recommended to close the manual service valves during any service / repair activity on the vehicle. Ensure adequate ventilation around the vehicle during repair works. Ensure the gas in the gas lines are consumed by running the engine with closed manual service valve and following the tester service for emptying the lines. Remove / shield the CNG tanks during the Welding / brazing work on the Vehicle. Get repaired / replaced in case of any damaged fuel system component. Use dry chemical (Class B) fire extinguisher in case of unlikely event of fire. Don’ts: Over filling the CNG Tank can cause safety issues. Please DON'T over fill the tank beyond its effective capacity (16 liters of water capacity for each cylinder.). Don’t park the vehicle near any fire sources. Never use naked flame / fire to check gas leakages. Never carryout any welding / brazing on the CNG cylinder. Avoid direct contact with CNG, it may cause frost burns. Don’t tamper any electrical or mechanical settings. For any clarifications please contact the Authorized TATA Service center.
RkJQdWJsaXNoZXIy MTIwNTUz