BODY 40 9.10. HOOD / FENDER / DOORS 9.10.1 R+R OF BONNET HOOD REMOVAL: a) Remove the connection for windshield washer from the connector. b) Unscrew and remove the 4 mounting bolts (2 in LH and 2 in RH) c) Lift and take out the bonnet. FITMENT: For installation follow the same procedure in reverse order but tighten all the mounting bolts to the specified torque. Ensure that the bonnet hood is locking smoothly and also ensure that the flushness is maintained .Check the condition of stay rod grommet and replace if damaged. Check the condition of hood inside lining and replace if soiled or torn HOOD INSULATION: REMOVAL: a) Open the bonnet and support it on the stay rod. b) Remove the intercooler duct (if installed) from the bonnet after unscrewing its four bolts as shown in c) Remove the 18 clips that support the hood insulation to the hood shell and remove it FITMENT: a) Hold the hood insulation on the hood panel inner and align it properly b) Fix the hood insulation to the inner panel c) Finally fix the 18 numbers of hood insulation clips to hold the hood insulation to the inner panel firmly. d) Fit the intercooler duct to the bonnet and tighten its bolts.
RkJQdWJsaXNoZXIy MTIwNTUz