BODY 26 INSTALLATION: 1. Fit the cooling module on mounting member of the car and tighten the mounting bolts. 2. Connect the electrical connections for temperature sensor & condenser fan. 3. Fill coolant (branded premixed ready to use coolant) 4. Top up coolant through auxiliary tank cap up to "Full" mark. 5. Fit Auxiliary tank cap. 6. Bleed the cooling system refer the engine cooling section. 7. Remove the trapped air though venting screw. 8. Remove AC system gas. 9.9.3 REMOVAL AND REFITMENT OF REAR BUMPER 1. Place the vehicle in the two-post lift or level surface. 2. Remove tail lamp. 3. Loosen the rear bumper bolts both the top and bottom ones. 4. Also remove the rear wheel arch screws as shown in fig 7 at both the ends ie on left and right hand side. 5. Remove tree clips from bottom.
RkJQdWJsaXNoZXIy MTIwNTUz