BODY 16 9.6.3 TAILGATE LATCH CABLE REMOVAL: 1. Remove the rear seat completely (Refer R+R rear seat). 2. Remove the C pillar lower end. 3. First remove the carpet on the left hand side of the vehicle so that the cable routing is visible. 4. Remove parcel shelf, parcel shelf support. 5. Remove tailgate sill cover. 6. Pry out the cable mounting clips. 7. Disconnect the end of cable from the Tailgate release lever and the latch (tail gate latch removal) 8. Pull the cable free from the vehicle. NOTE: Follow the above procedure for RHD vehicle, only the right hand side of carpet needs to be removed. FITMENT: 1. Route the cable as shown in fig passing through the cutout in the tailgate sill inner. 2. Connect the end of the cable to the tailgate release lever and the tailgate latch through the opening in the tailgate sill. 3. Fix the cable in place using its clips 4. Fit the carpet finally. 5. Fit the C pillar trim bottom 6. Fit the rear seat over the carpet. 7. Refit parcel shelf. 9.6.4 FUEL LID CABLE REMOVAL: NOTE: Before pulling out cable ensure to tie suitable thin wire at the cable end. 1. Pry out the front seat lower trim to remove the cable end from fuel lid and tail gate release lever. 2. Remove the cable at fuel lid end. 3. Remove the lid from assembly fuel filler housing. 4. Pull out the cables until u get to see thin wire. 5. Now disconnect cables to be replaced with the thin wire.
RkJQdWJsaXNoZXIy MTIwNTUz