BRAKES 55 INSTALLATION OF CABLE Carry out the above steps in appropriate sequence for its fitment. NOTE: 1. Fit the cable to the brake shoe lever. 2. Fit the parking brake cable clip to the brake back plate securely. INSTALLATION OF PARKING BRAKE LEVER 1. Proceed in the reverse order of removal. 2. Tighten the mounting bolts of the parking brake lever to the torque specified. 3. Adjust the parking brake cable slackness as per the procedure given. 4. Reconnect the electrical connections to the parking brake switch assembly and confirm that the parking brake lamp becomes “ON” when parking brake lever is at first notch. 7.10.7 PARKING BRAKE CABLE ADJUSTMENT 1. Before parking brake cable slackness adjustment confirm the following conditions. 2. Bleeding should be completed. (i.e. there should not be air trapped in the brake system). 3. Confirm pedal travel by depressing the brake pedal for few times. 4. Check the lining condition of the rear brake, it should not have been worn out beyond limit. After confirming all the above points, start adjusting the parking brake lever stroke by either loosening or tightening the self-locking slackness adjustment nut. For details refer maintenance section.
RkJQdWJsaXNoZXIy MTIwNTUz