DRIVETRAIN-TA65 Star 22 CLUTCH CABLE 5.6. D. CLUTCH CABLE REMOVAL AND INSPECTION: REMOVAL 1. Remove the clutch cable nut and disconnect the joint pin from inner cable.at the clutch housing end. 2. Disconnect the cable from hook at clutch pedal top. 3. Loosen and remove the two clamps holding of the clutch cable on the firewall, one at the transaxle end and other at the engine end. 4. Remove the cable from clamp on transaxle. 5. Similarly loosen and remove the cable at the passenger compartment clutch end. INSPECTION Replace the cable if a) There are any bends or kinks. b) The cable is having a worn end. c) The boots are broken. INSTALLATION 1. Grease the joint pin and cable end hook. 2. Fix properly the clip for holding clutch cable on firewall inside cabin. 3. Hook the cable end with pedal from inside the cabin. 4. Join the inner cable with joint pin in release arm. 5. Ensure the heat resistant sleeve is in front of the exhaust front pipe. 6. Fix LH side cable holding clamp on firewall. Ensure that cable is free in the clamp. 7. Adjust the pedal height according to specifications after the clutch cable nut is fastened on to the cable. 8. Finally check the clutch for proper functioning.
RkJQdWJsaXNoZXIy MTIwNTUz